Recent content by Pilgrim55

I just installed a new clutch kit in my 2012 jk Rubicon after getting the new clutch installed and transmission and transfer case put back together with a friend help. I sure all the components were properly torque down. When I installed the slave cylinder it blew up and leak, though I miss up...

Thank you for the help

I have a 2012 jerk jk Rubicon with a 6 speed manual transmission. When I shift it into first gear it pops out of gear frequently, when I shift it feel like there our two notches going into first. I have watch videos about replacing the shifter with B & M 45195 shifter would fix it not sure if...

Best Top sent the wrong door surround for my Jeep does anyone know what these fit. They told me to keep them and are sending me the correct ones. Anyone know what they fit on? Sent from my iPhone using WAYALIFE mobile app

Sent from my iPhone using WAYALIFE mobile app

I have a Hard Top I am Thinking sale. It is a jk 2 door I am not sure what it is worth any help would be appropriate Sent from my iPhone using WAYALIFE mobile app

Sent from my iPhone using WAYALIFE mobile app

Here what I did to fix it Sent from my iPhone using WAYALIFE mobile app

Here is some pictures Sent from my iPad using WAYALIFE mobile app

I weld on the bolt inside the the frame broke lose on the bushing that hold the sway bar to the frame. The only thing that I can think of to repair it is cut a hole in the frame and weld a new nut to the frame and then weld the frame back up. I believe It is a M14 nut I have seen rivets up to...

cj3b Love your CJ3B had one when I was much younger

Blue Thumder

I have a 2012 jeep Jk Rubicon when I lock my lockers in rear work good but my when I put my front locker on the engage solid light but i noticed that my front lock light blink irregularly but they are still locked in. On the way home in 2 wheel drive I noticed that my front locker lights was...

I have a 2012 jeep Rubicon 31/2 in lift. I had side to side movement in front tire replaced the Wheel Hub think that would fix the problem. Ball joint are good replace them awhile back with dynatrac ball joints recheck them no movement. When I finished the I check the side to side movement...

I have a 2012 jeep 2 door Rubicon with 35 tires on it my driver side front wheel bearing is sloppy. I have found different brand of Hub assembles is on brand better then the next or does it really matter other than the cost? I have look for torque setting I on the 36mm axle nut 175 # and 100#...