Recent content by oGKevin

Wave from the East Coast! I'm purchasing a supercharged 3.8l from a member on here and I didn't ask him about the exhaust. I was hoping you guys could help me. Is it absolutely necessary to upgrade the exhaust? I plan on doing it, I figure doing it all at once would make the most sense. Can...

Looking to buy a new engine to replace my friend one. Currently have 93k miles on the 3.8. Looking for a low mileage 3.8 or newer 3.6 engine. Hoping one of you guys did a swap and can hook me up. Hoping my shop could swap the 3.6 in easily enough. Located in Northern Virginia. Will drive up...

So while I was at school my dad drove my Jeep and managed to put around 2500 miles on it. I changed the oil and only got 1 quart out of it. I took it to my mechanic and he said this "clicking sound" I was experiencing would go away. Long story short, it didn't. Oil pump went bad and didn't pump...

Hey y'all, My auto 2007 JK is due for an oil change but recently the oil light has been flashing on and off randomly, mostly when accelerating or braking more rapidly than normal. I don't want to change the oil if I'm going to have to drain it to fix this problem. Does anyone have any ideas on...

Almost done :rock:

EVO Corners/Tire Carrier installed. Not too shabby. Fascia and bolt-ons will be done in a warmer climate soon. :rock:

Got it all done! Looks great, thanks for the help!

Hey y'all, I just finished up my 1/4 pounder and I'm about to start the backend. Just wanted to post to see if anyone whose installed these before had any tips or tricks that would make it easier, better. Perhaps a type of drillbit or a specific brand of RTV silicone. I'll be painting...

Thanks! Sure - It was made by the previous owner out of wood and has since been replaced by a backseat and a toolbox. Here's a pic of it, kind of. It was 2 pieces of wood on a piano hinge. It went down behind the front seats and to the back, at the tailgate level.

Everything I need for my corners and tire carrier are here!

1/4 pounder is done. Corners and tire carrier are next.

Done! EVO Corners/TC/Fascia/Rear D rings are next

Almost there! Drilling holes for the stinger is a bitch, any advice?

1/4 pounder is almost done. Rigid Industries 10" lightbar needs to be mounted and it'll all be on the Jeep tomorrow. Beginning work on the rear bumper for the fascia/d rings also. Worked all day, outside, in 19 degree weather :icon_crazy:

Starting to look like something. License plate will be offset so I can run the Factor 55, I really like the way they look. I'm going to shred this aluminium fairlead with my steel line, but synthetic is on the way. Next it to mount the 10" Rigid bar and get everything on the Jeep.