Recent content by mtnbiker995

Here is a picture that my buddy sent me of a JK's fusebox. It shows which fuses are always hot, "ignition on" hot, and accessory hot. It also has labeled which side of the fuse the power comes from, just pay attention to where the circle is. Sorry if this is already posted on here...

Has anyone who has a Poison Spyder BFH cut their grill? I have a friend who is interested in this but we can't really find a write-up or any good pictures of what it will look like. So, if anyone has done this or knows of someone who has, please post up some pics so we can get a better idea...

Ahh okay thanks for the responses guys. This is my first OBA system so I have no idea how much rust is normal or not. And the system came with a brass fitting where my cast one is, but I couldn't for the life of me find an air hose to fit the compression fitting. So I removed it and put an...

I've had it installed for about 6 months, and I don't always use the OBA so I normally try to drain the tank after each trip where I've used it. I'd say <15% of the time I've had the system installed has it actually been pressurized

I have a 1.5 gallon Viair system mounted inside my cab. Yesterday I dismounted everything and brought it inside my house where I removed all of the fittings from the tank and looked inside. . .The whole thing is covered with pitted rust spots on the inside so my question is, what's the best way...

Snow banks along side the road are about a foot taller than my Jeep! Sent from my iPhone using WAYALIFE mobile app

I'm looking for a rear driveshaft for my 2009 2DR w/ a manual transmission

I'm looking for the EVO rear corner armor WITHOUT the fender flares. . .I'm looking to run flareless in the rear. I've posted a link to the type of corners I'm looking for. I might be interested in other brands too, let me know what you guys have. Thanks...

My buddy bought his jeep used and these control arms were on it with about 3-4" of lift. He went to long arm and gave these to me but neither of us can figure out what brand they are. Does anyone have a clue what brand they are so I could buy rebuild kits for the joints? Thanks in advance...

Sent from my iPhone using WAYALIFE mobile app

Superbrightleds.com I have their 21" off-road LED light bar

Rancho, How can I find the Pro Series Coilovers on your website? The only way I can find them on your website is if I google Rancho Coilovers and then click on a link. I don't have a question directly about them, I'm just wondering how to find them easier. Thank you, mtnbiker995

I can't think of anything that would be of benefit over hooking a d-ring. . .not all bumpers have d-rings though so this could be a possible rattle-free solution for that

I spool mine up then loosen it a little bit and hook a shackle...it'll unravel the first 5 or so feet of line but when you use you're winch it'll most likely be longer than a 5ft pull and you'll have to unspool even more. What I'm getting at is that a few loose wraps should be fine Sent from...

Yours rolls off the top? My ENGO rolls off of the bottom of my drum