Recent content by mayday_soc

What are the benefits (and negatives) when switching to a heim joint steering setup? Most of the research I’ve done compares them to Johnny joints relating to control arms. I’m only concerned with the tie rod and drag link. Is one better than the other with: a big bore setup? Inclement weather...

I’m going to try and loosen the few zerks I’m having problems with. Sounds like that’s my problem. Whoa... Thank you for the link. Looks like I’ll be drilling some holes next weekend.

I was wondering the same thing about Johnny joints. Some joints fight the grease gun and won’t take any grease. Others take plenty and it oozes out and I wonder if that’s good or bad. And other joints like the lower control arms I can’t reach whiteout dropping the arm so I never grease them. I...

Whoa! Thanks for timing it. I’m going to have to investigate mine further. I’m going to try dipping a paint brush in the soapy water and hitting all the seams.

That’s how my compressor works ...but every 1:50 it kicks back on for a second. Even if I just fill the manifold and and don’t use any accessories like lockers, swaybar, etc. I’ve gotta have a leak somewhere.

I have NOT checked the black end caps. Damn, I def have a leak from what you guys are saying.

I’m not trying to start a competition or anything. I’m just looking for what would be considered a reasonable amount of time before the arb compressor kicks on to recharge the air manifold after it’s initially turned on. With no accessories on, how long should it take? Mine kicks in for a...

Looks like they’ve been recently discontinued. Any recommended vendors of this site that may stock them?

Only an idiot would chop their rear frame... But let’s just say they did. What’s the best way to repair it to install the EVOlever system? Chop one off another Jeep? Get the Genright repair kit? etc. etc. Asking for a friend.

So I joined the forum the end of ‘16 when I bought my first Jeep but never post much and never gave a proper wave. I do a lot of lurking on this forum. It’s my go to for research and the only forum I trust. I just wanted to say hello and thank everybody who takes the time to post about their...

Hello everyone, new member. Searched the forum as to not waste anyone's time but is the AEV Procal the only way to turn off the sway bar light when using the No Limits? I'd much rather run the Superchips flashcal for the dummy screen and to read engine codes as they pop up. I can't see using a...