Same happened to me 2008 JK. Make sure your gas take is full or close to full. I recall reading it wont reset if gas it too low. I dove 200+ miles with no luck. filled the gas tank and got it reset soon after. good luck.
Super Helpful. thanks a bunch. i did get hung up with the pry bar for the dipstick tube. i just couldnt get it to move enough. I opted to use a strap on the dipstick tube. fed the strap behind the enging to the other side, hooked it up to my driver side tire rim and gave it a couple good...
the jscan OBD can read wheel speed sensor outputs. might be helpfull to ID which wheel speed sensor is acting up. this is could also be triggered from a faulty ABS module ( im seeing this on my jeep now. however all these light come on once my jeep hits about 5 mPH and stay on till i...
check out Dupli color spray on Custom wrap. i just did my front gril and metal windshield wiper hood piece( both in matt blk). make sure to use lots of layers. mine came out good. if it gets nicked up just spray on more. if you don't like it peel it off.
Not a expert here. But seems most of the items you mentioned you had issues with work on the ‘internal’ CAN Bus system. I’ve heard of issues where modules within that CAN bus system malfunctioning and send faulty communications on the bus just enough to cause problems with other devices within...
Anyone know if ‘stored’ codes will clear by themself. 2008 wrangler 3.8 Battling CA emission nightmare. I’m hearing competing info regarding the state of stored codes in a smog check. Thx
Sent from my iPhone using WAYALIFE
Pulled the cylinder head, got the broken bolt out. Now to put it all back together. Wouldn’t have attempted this without all the info from this forum[emoji106][emoji106]. Thx All.
Sent from my iPhone using WAYALIFE
2008 jeep jk, ~110k miles.
My jeep has a ticking sound coming from the driver side engine compartment. It is very faint/non existent when not under load only when under load ( ie in gear and driven or when in gear and rev’d while holding the brake). It started with a low volume ticking about...
Hey all. Been a member for a while. Apologize for the late WAVE. I've gotten a lot of great advise and info from the members over the years( Thank you). Hope to be able to contribute a bit going forward.