Recent content by Hooligan

attach]85821[/attach]

Looking to buy some spacers. Pm me if you ate ready to sell. Thx

Took carrier apart. The trac-lok clutches had worn away leaving the spider gears loosey goosey. Pinion gear and ring are still good. I replaced the trac-lok with new dana clutch packs and replaced the spider gears. It's really tight in there now. It was hard work rebuilding the trac-lok due to...

Pulled the cover to further investigate the metal fragments found when I changed the fluid. Every tooth on both ends of that center pc is chipped. Im guessing thats the part of lsd . When i turn a wheel the other one does not turn. If i move the left wheel back and fwd quickly theres some...

Loosened all control arms ,track bar and disconnected sway bar. Shook it out and then torqued to spec. No change. Had the wife turn the wheel while I checked the TRE's they all look good. Changed front diff fluid and rear diff fluid. No change. Did find some metal pcs in the rear on the magnet...

this is before I removed the 8 bolts. Ive beat the shit out of it and it just wont come loose.

Removed all bolts. Axle end dropped no problem. Cant get the t-case end to come out. Ive banged on shaft with mallet and it just wont break loose. Any tips?

I have a vibration that can be felt in the gas pedal,steering wheel. Feels like its under drivers seat or front end of the jeep. It happens when i hit a bump..the vibration starts..i let off the gas and it goes away. Back on the gas and its still gone until the next bump. Cannot reproduce the...

Is my drive shaft done? The boots not torn but the grease has obviously been coming out. How does the angle look ? 3" lift with stock arms and lca drop brackets.

Happens at idle and around 2000 rpm. Not noticable while driving. Its bloody cold today.https://www.youtube.com/watch?v=0B_lxySoTsY&feature=youtube_gdata_player

before after

So I'm about to install my new coils. The current setup is screwed..supposed to give me 4" but actually yields only 2.5 up front. Just double checking procedure: Jack front end and remove wheels. Place jack stands under frame at control arm mounts. Disconnect front sway bar links. Disconect...

Evo plush ride 3" coils. Sweeeeet:beer:

I measured the front at both points using the spring perch and the shock bolt to upper bracket method. I'm getting just under 3" out of the pro crap 4" springs.( Stinger bumper and winch). Is there anywhere at the rear I can take a measurement to see what the rear springs are giving me. I'm...

Just had my balljoints done. Mechanic noticed my front springs are very compressed and dont decompress when the axles droop. The springs are pro-comp and supposed to give 4" lift. Rears seem ok. I'd like to replace when I have some extra cash. Wouldn't mind dropping to a 3" lift. Question is my...