Bizcuit's latest activity

I too can attest that trucks are not Jeep suspension in many ways, but in the one way they’re similar, I think would help the O.P. I...

I respectfully disagree, it’s what steers a skateboard. I have a friend that did an LS swap that couldn’t do WOT launches until he added...

The closer you have the control arms level to the ground the better it’ll handle. Obviously there is a trade off with low hanging parts...

Thank you. My last Jeep was a Wrangler, which I was very proud of. Had a lot of money and time in it. The mistake I made was not going...

Thanks Mike.

This setting is 5 1/2 inches of uptravel. Plenty of tire clearance on the LCA at 40 degrees of turn. In the full body picture you can...

If she wasn’t see so set against it, 42s would have fit.

Hard passenger everything lines up nicely.

In these shots you can see full stuff hard driver. The drag link does touch in this scenario, maybe because I mixed Apex with Yeti. At...

There’s a small relief notch on the top of the cylinder bracket for the track bar. The cylinder is parallel to the tie rod.The tie rod...

Track bar bracket. Its slightly taller than the Dynatrac and weeded of the stabilizer hardware.

Axle end brackets. I have the struts pushed out to the knuckle weld is why it’s offset. This puts the strut at 14 degrees when bumped...

Powdered the towers semi gloss, then ground the weld areas. Also applied POR15 to all the bare metal. About 3/8 clearance on the...

Clamshell is done. I now have all three links welded and in place. Should be able to get some real measurements tomorrow. Backbone is...

Here’s the axle end which is also made of 1/4 plate. It needed a relief behind the cylinder for the track bar.