Recent content by Ben-0

not the best pic fellas but this was the issue the connection was pretty corroded cleaned it up sprayed it down and as good as new 👍

Has anyone had problems with these? I just lost my driver side last night while driving home. It flickered went out then came back on shortly after and then back out again and hasn't come back. My real question is has anyone had a similar issue and if it's the led can it be fixed or is it just shot

So all I need is the two bolts to unscrew put the bracket on and screw them in...easy right? Well the inner most screw on both sides will not unscrew any insight on that? Are they not supposed to come out? They turn like there is a nut on the inside that is turning with it Thanks guys

Just got a light bar and almost done with the installation just need to put the switch by the hazard light just not sure how to pop that plastic off without breaking it so figured I'd ask first here Thanks guys

My brother catches and relocates rattlesnakes for the pipelines and stuff, he's working now in nj where there putting up the real high electric wire he sent me this one the other day

took my tb off to clean as regular maintenance and I'm looking at the worst sludge iv ever seen on a tb...this is my fist jk and have had it for a little under 3k miles. Not real familiar with the 3.8 either, should I clean that manifold? Throw me your ideas or knowledge Thanks guys

All the seals look fine....now what? Should I add a seal to the door surrounds where the door seal is supposed to be tight? Thanks guys

just grab this pic from a write up, but I'm saying like most people do it like this, but I'm wondering if I can just moc a cart like up that is the same as it sets on the jeep meaning flat and not leaning

So it's soft top season in good ol New York, I know a lot of people either make carts or buy carts that store there top up with the weight on the back of the top...I was thinking is there any reason not to store if flat...I have pallets laying around the shop and was thinking I could moc it up...

So I was going to change the fluid in my transfer case today so I put it on the lift and put the impact on the bolts to take the skid off, all come off fine other than the passenger side it got about 3/4 of the way off and wouldn't move, either way tighten or loosen. So I didn't really have to...

Sea foam is not a waste of money by any means...I live on a farm and we have one of the first bob cat skid steers, it will not run unless sea foam is mixed in the gas, I use it in all my vehicles sporadically...did a full treatment on my 1976 Cherokee chief when I first got it seemed to clean it...

Good luck everyone! Thanks for the opportunity that's literally the next step to starting my build

Por-15 is an amazing product that I will stand by and use on all of my important vehicles, I painted the whole undercarriage of my 72 f100 it makes it look show quality even when its dirty and will never rust I plan on doing my jk pretty soon here 100% worth the time effort and money

just thought i would share this info http://www.4wd.com/promo/pdf/Rancho-March-2013.pdf

Kinda new to this they have co2 systems or tanks for filling tires? Why haven't I heard if this? Any links or anything, I own a paintball field and have both co2 and compressed air systems, I can fill both and I have tanks for both but I wouldn't figure any of the tanks I have would be enough to...