Recent content by Ali

Can you please tell me where is the stamp location if it is a JT front axle where should i look?

True i bought 186mm front ring and pinion with the shipping to my place it cost me 750$ and the ring and pinion is 38-11 (3.45) but is much smaller in dimension then what i have 🥴 i think its a Gladiater front D44

I can swap the rear axle but i need to reprogram the pcm i dont have teaser if i could understand what is the front axle housing i would have bought the ring and pinion and installed it to finish this night mare 🤕

This is the diffrential cover

I know that but i need to change the front axle ratio to 38-11 (3.45) to be same ratio as the rear axle but my problem i can not recognize what is the front axle its not a dana 30 and maybe it is more like a 44 with out locker i am confused i bought m186 38-11 ring and pinion amd its smaller in...

I Got this jeep with broken OEM front axle that have been swaped in U.A.E by not qualified persons the car gets stressed stuck when put to 4 hi amd 4 low after i found as the build sheet i found that the axle ratio on the jeep must be 3.45 with overall top gear ratio now i have problem with...

Hello there i will change it and report back its a crazy case it gives randomly at start up cold start some time it goes away no codes for weeks or days and some times its back again it drives me nuts

I am on it the 5 volt of app 2

I have done the relearn programing more then once it does through the code again and again at random times

Ho there i have the codes i changed the list bellow and no luck Codes are P0121 and P02135 they come randomly at first start or cold start and go away if i restart the car they keep throughing the code at random times some time i see they dont come back my problem is at 4 low of i push the...

high there i have Jeep Wrangler Rubicon 2013 with Dynatrac D60/60 package i was looking who could build me the exact same like rde2rok red jeep any one could help me i would appreciate your help here is my jeeps full specifications JKU Dana 60/60 with e lockers and Atlas TC on 40" tires and...

I am looking to high steer + PSC for my 2013 jku rubicon with edlbroke supercharged engine and dynatrac axles any one can help where can buy it online or who may help me to build this kit for my jeep What i meed is 1- high steer system just like the red equiped jeep 2- PSC that fully works...

hello there here is my set up i just installed both bolt on coil over from evo and long arm bolt on kit my problem is the Adam drive shaft is now there is only 1 inch lift (pictures with red circle) to get out of both the sides please advice what name or brand should i get that has the...

Hello Jeepers i need to know some information from experts here for non extreme off roader my dana 30 Holds some abuse after c gussets and truss kit but keeps blowing internal ring and pinion or spider gears if i push too hard with 37'' tires what i look forward is i need to buy a better front...