For use on 2021-Up Jeep Gladiators only
The WAYALIFE Jeep JT Gladiator Antenna Mount is designed to be installed on either side of the truck bed bulkhead, just behind the rear window and using existing holes. The mount is made out of unfinished, laser cut and bent, 3/16" thick stainless steel and it comes complete with stainless steel hardware for optimum performance and corrosion resistance. Installation is super easy and can be done in just minutes using basic tools. While the mount is intended for use with a CB antenna, an optional NMO adapter can be purchased separately to allow for the use of GMRS and race radio antennas. The mount can also be used to install a small rear facing light or flag.
• Designed for truck bed mounting of a radio antenna
• Optional NMO style antenna mount can be installed
• Allows for the installation of a small light
• Will work with some tonneau covers*
• Made out of stainless steel
• Includes stainless steel hardware
• Perfect for use with an ACC BAR
• Easy to install and with basic tools
MADE IN THE USA
Click here to see our
JT Antenna/Light Mount Installation Write-Up
BUY the following to complete your Antenna Mount for NMO
NMO Antenna Adapter for GMRS & Race Radios
NMO to UHF (SO-239) Female Adaptor
Rugged Radios NMO Style No Ground Plane Antenna
Wilson 18 foot coax cable with Adapter
ACC BAR Overhead Accessory Mount
NOTE: This antenna mount is purposefully left unfinished. If you choose to paint it, you'll need to make sure to mask off and leave the antenna stud mounting hole bare steel. This is important for proper ground.
Please be sure to review our
Return Policy prior to placing your order.
*
For use with tonneau covers that do not use the same mounting holes on the bulkhead.
Please note that the Amazon links posted are associate links and WAYALIFE does earn a small kickback for purchases made through them. 
