Search results

And they'll tell you the price with a straight face, not even bat an eyelid lol

I got 100 rivets same as OEM Mopar rivets for 9.99 on Amazon Jeep dealers will charge over 4 dollars per rivet!

You have to remove most of the existing plastic rivets and install new ones with the flares some drilling is required took me 15 minutes for all four fenders easy job!

Tire Poke

Thanks!

Thanks!

I just installed a JKS 3"lift on my 2023 2dr Wrangler Rubicon, and the adjustable lower control arms don't have a stud for the brake bracket Zip ties, Duct Tape? 🤣

Thanks!

Finally got the lift done!

Moab Silverton and Sedona as well as Las Vegashttps://www.facebook.com/share/p/Q21LLbDVPcKwaYbs/?mibextid=ZbWKwLhttps://www.facebook.com/share/r/agsft3FSY3mQDrHr/?mibextid=ZbWKwL

Oh, ok thanks for the info

I don't know if it's my phone but I was trying to upload videos this summer while I was out in Moab and was unable said file too large I may have to try with my PC got some great video of Moab and Colorado

Resident Smartass 😂

13,300+ did a cross country trip this past summer hit Silverton CO, Moab , Sedona and Las Vegas as well as some wheeling in PA

It's as nimble as a Fox on the trails and aside from getting high centered a few times while taking on some tough trails it's pretty capable only "oh sh*t" moment was going down a steep sandy ledge that I had some real trouble getting back up ( I was alone on the trail) and it was before I had a...

Thanks 👍 appreciate the advice!

I've done serval trails in Moab and AOAA/Rauch Creek in Pennsylvania got high centered on Fern Ridge black loops and Steel Bender in Moab and slowed down the whole group several times 😂 I figure 3in lift and 35s I would avoid the trouble

The 3" lift from JKS is a much better product than the 2"Mopar lift and I will probably go with 37s eventually I was thinking that if I go with 37s I would need to go with steel steering knuckles and HD ball joints What's your opinion? Re: steering knuckles and ball joints

Thank you 👍 I most likely will be adding the jks 3 inch lift and aftermarket rear drive shaft as recommended I just thought it might be a little more tippy being total +or a little - 4" over stock center of gravity which is my concern (rollover)