Recent content by rob_bunch

I crawled this past weekend with an actual buggy, a tj and a jl,,, both the tj & jl were up at least 4-6 inches and on 40’s,,, my thought was to go high line fenders and 40’s and that to add in longer arms to maybe add a little more articulation

Only running the armor that is over my rockslide engineering steps and I’ve not added bell skids yet

Looking for input from those of you running long arm kits on the JLU. My current setup is an Evo 3.5” stage ll overlander,, about to go high line flares and 40’s and was considering keeping the same springs but going to long arms (if that’s even possible) in an attempt to keep cog low. Is this...

C1252-92 U1514-87 P258B

Well considering this forum is typically the most accurate, this is the only one I usually go to. Additionally most of the time, members here seem to be a bit more inclined to be helpful and not so condescending or dismissive.

Considering no one replied,,, I took it as either no one knows the answer or nobody saw it so I just reposted it. If there’s a previous write up on this issue it doesn’t come up when I search the forums for it.

So I’m getting those weird codes for Abs and vacuum pump ( y’all know the ones I’m talking about) and I wanted to get y’all’s opinion on what to do next. I recently went to an Eaton elocker and new axle shafts and the lights were on before that. Now I have changed the vacuum line & the vacuum...

So I’m getting those weird codes for Abs and vacuum pump ( y’all know the ones I’m talking about) and I wanted to get y’all’s opinion on what to do next. I recently went to an Eaton elocker and new axle shafts and the lights were on before that. Now I have changed the vacuum line & the vacuum...

I’m in the market for my first set of beadlocks,, and as KMC goes, I am wondering what the difference is between the Grenade crawl the Grenade desert? Is ot nothing more than a different beadlock ring? If anyone knows please advise! Thanks

As beadlocks go, what is the difference between the KMC Grenade crawl vs the Grenade desert? Is it nothing more than a different beadlock ring?

Anyone with running an Evo 3.5” overland lift get brave and run 40’s while still having oem fenders in place on a JLU Rubi ? Asking for a friend….

So that was why the factory locker was changed originally,,, now the plastic plate inside this thing is broken and I don’t want to go back with the same molar junk. I need a viable option to replace the locker. And are the rubicon factory axles 32 spline?

Suggestions on where to shop for them?

Well for one the cost,,, if I go air route, it’s not just the locker but then an onboard compressor. I do t have 2grand just laying around at the moment. I need to get it back on the road as efficiently and cost effective as possible.

I have a question regarding aftermarket lockers for an 2018 JLU Rubi.. At 75k I had the first rear locker changed under warranty because the locker lights and trac light started flashing,,, well it happened again at 115k and so I bought the tazer bypass pigtail & problem was solved. A few weeks...